Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How do you straighten a bend ?
#1
[center][font "Poor Richard"][green][size 4]Have an old bamboo rod which has a bend in the rod's tip section. See picture. Any suggestions on how to straighten this out? Thought about applying steam but I'm afraid that might loosen the adhesive, varnish etc.[/size][/green][/font][/center] [center]
[/center] [center][Image: gforum.cgi?do=post_attachment;postatt_id=11390;][/center] [center]
[/center]
[signature]
Reply
#2
the way I have straightened a fiberglass rod is bend it in the opposite direction and leave it for a while and hit it with a hair dryer. one thing I've noticed about old hexagone 3 piece rods is that they have slight curves to them. the one I have is bent the ones my 2 friends have are also. later chuck
[signature]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)