Fishing Forum › Float Tube Fishing › Float Tubing General v
Pontoon wheel ??

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Pontoon wheel ??
DavePa Offline
Bait
*
Posts: 9
Threads: 0
Joined: Jun 2012
Reputation: 0
#6
02-26-2013, 05:26 PM
Pattern simply made with a piece of cardboard
Sorry for the poor pics!


20" deep
47" wide
Inside measurements

[Image: C89D824E-B48A-45A5-A91A-FC08734359E6-395...DB17B8.jpg]
PLUS 1 1/2 folded lip around edges

I left gap at rear corners for water to run off.
Front corners are notched to fit around bar and still be able to use frame pins. Mine required 7" deep by 4" wide
[Image: 75ADF93A-BC6F-4D01-84CE-C26DAD4DF2C8-395...1B79FA.jpg]
Motor mount 7" wide 5" high
Height may vary if using gas due to shaft length ... Electric won't matter given the shaft adjustments on most trollers.
[signature]
Find
Reply


Messages In This Thread
Pontoon wheel ?? - by DavePa - 02-26-2013, 03:20 PM
Re: [DavePa] Pontoon wheel ?? - by cpierce - 02-26-2013, 03:51 PM
Re: [cpierce] Pontoon wheel ?? - by DavePa - 02-26-2013, 04:21 PM
Re: [cpierce] Pontoon wheel ?? - by DavePa - 02-26-2013, 05:26 PM
Re: [DavePa] Pontoon wheel ?? - by TubeDude - 02-26-2013, 04:26 PM
Re: [TubeDude] Pontoon wheel ?? - by DavePa - 02-26-2013, 04:52 PM
Re: [DavePa] Pontoon wheel ?? - by valley_sports - 02-26-2013, 07:15 PM
Re: [valley_sports] Pontoon wheel ?? - by DavePa - 02-26-2013, 08:11 PM
Re: [DavePa] Pontoon wheel ?? - by cpierce - 02-26-2013, 08:23 PM
Re: [cpierce] Pontoon wheel ?? - by DavePa - 02-26-2013, 09:07 PM
Re: [DavePa] Pontoon wheel ?? - by idahoron - 02-27-2013, 05:35 AM
Re: [DavePa] Pontoon wheel ?? - by idahopanfish - 02-27-2013, 01:57 AM
Re: [DavePa] Pontoon wheel ?? - by flygoddess - 02-27-2013, 06:10 PM
Re: [flygoddess] Pontoon wheel ?? - by DavePa - 02-28-2013, 01:36 AM
Re: [DavePa] Pontoon wheel ?? - by idahoron - 02-28-2013, 05:31 PM
Re: [idahoron] Pontoon wheel ?? - by flygoddess - 02-28-2013, 09:06 PM
Re: [idahoron] Pontoon wheel ?? - by DavePa - 02-28-2013, 11:59 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)