Compact Motor Mount

[TubeDude]

[cool][#0000ff]The design will work on any "V" tube. The variables are in the size of boat bumper floats you use and the distance between the bottom D rings and the end of the tube.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]There are three component parts...the float pack, the basic frame and the motor mount riser. You start by getting your floats and setting them up for mounting. Then you build the frame so that the connectors on the float pack fit into the frame at the right points. After that you vary the length of the connections in front to get a proper fit. [/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]It takes some measuring, cutting, fitting and remeasuring and recutting to get everything to go together right. The nose portion on the 420 is not quite as thick as on the Fat Cat but that will all be taken care of during the fitting process.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]I will be putting together a more detailed instructional PDF file in the next few days. If you would like a copy you can send me a PM and I will make sure I send one to you.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]I have already helped set up a couple of ODC 420s with motors...using the top frames. [/#0000ff]
[signature]