10-06-2009, 01:03 AM
I use a jet sled and have been trying to work out a multi-use sled with some comforts.
In this picture you see most of the loose gear.
The duffle is the tarp and frame work for the wind break. The 10" auger.
The buckets have the rod holders and jiggers ( if you need a taller bucket, cut the bottom out of one and put it inside another and use a round head screw screwed from the inside, into the point where the wire handle is in the outter bucket, shouldn't snag on things as much)
The spoons (notice the foam on the handles, so when they head for the hole they will not sink away) will be on the floor by the auger.
The wooden box (now an aluminum box) holds rods, tackle, stove, tools, sonar, bait, etc.
[inline "broken down for trasnport (Small).JPG"]
This is the windbreak and does a nice job if the wind isn't too strong. As you can see the box becomes a bench and the stadium chair gives my back some support.
[inline "setup (Small).JPG"]
I will be incorporating more rod holders in to the pvc frame to make moving easier and have rods with different setups ready ( we an have 5 rods here in Idaho)
[inline "IMG_3710 (Small).JPG"]
[signature]
In this picture you see most of the loose gear.
The duffle is the tarp and frame work for the wind break. The 10" auger.
The buckets have the rod holders and jiggers ( if you need a taller bucket, cut the bottom out of one and put it inside another and use a round head screw screwed from the inside, into the point where the wire handle is in the outter bucket, shouldn't snag on things as much)
The spoons (notice the foam on the handles, so when they head for the hole they will not sink away) will be on the floor by the auger.
The wooden box (now an aluminum box) holds rods, tackle, stove, tools, sonar, bait, etc.
[inline "broken down for trasnport (Small).JPG"]
This is the windbreak and does a nice job if the wind isn't too strong. As you can see the box becomes a bench and the stadium chair gives my back some support.
[inline "setup (Small).JPG"]
I will be incorporating more rod holders in to the pvc frame to make moving easier and have rods with different setups ready ( we an have 5 rods here in Idaho)
[inline "IMG_3710 (Small).JPG"]
[signature]