06-24-2003, 10:53 AM
[cool]Hey, 'TOONERS"...I was playing around with some designs and I think I have a quick and easy attachment to the back...between the air chambers, that will allow the simple mounting of both rod holders and transducer rods...even the golf club shaft applications.
I plan to make a decent diagram and instructions when I get the time, but essentially it is an "L" shaped contraption...wider across the horizontal surface, which attaches to the frame, and only about sixteen inches on the downward portion...to which you attach the rod holders.
If you have access to a piece of sturdy aluminum sheet you can bend and cut to fit...or heavy molded plastic sheeting...it can be lightweight and simple to clamp or screw to the frame. Even if you have to make it from wood, it shouldn't add too much weight, and will make "add-ons" easier.
Look for a diagram on a separate post later today or tomorrow. Schedule is kinda hectic and I am already writing this at 4 in the morning. Impressed?
TubeDude
[signature]
I plan to make a decent diagram and instructions when I get the time, but essentially it is an "L" shaped contraption...wider across the horizontal surface, which attaches to the frame, and only about sixteen inches on the downward portion...to which you attach the rod holders.
If you have access to a piece of sturdy aluminum sheet you can bend and cut to fit...or heavy molded plastic sheeting...it can be lightweight and simple to clamp or screw to the frame. Even if you have to make it from wood, it shouldn't add too much weight, and will make "add-ons" easier.
Look for a diagram on a separate post later today or tomorrow. Schedule is kinda hectic and I am already writing this at 4 in the morning. Impressed?
TubeDude
[signature]