Rod Holders?????

[utwalleye]

here's a couple pics of the brackets I made. I used a 3in. alum. angle iron and a piece poly, poly is somthing like a plastic but stronger. I cut the poly to fit in my downrigger
base mount. then I cut the angle iron about 1\4in. smaller on each side and boltted it the the poly. I had to counter sink the flathead screws so the would slide in the mount. then I had to cut (drill) a small hole for the locking pin pn the base mount. it all seems to work great for me. hope this help you guys out. later chuck
[signature]