Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Painting spinner blades
#16
[cool][#0000ff]Been there, done that. My wife and I had a good laugh the last time I was putting glow paint on some lures. I did a batch late in the evening. I thought I had gotten all the residue off my hands, but there were a few specks of the glow paint mix left on a couple of my fingernails.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]You guessed it. After lights out there were some bright green specks of light before my eyes. That glow powder is powerful stuff and I had "fingernail fireflies". They were still glowing when I woke up in the middle of the night.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]All of that comes under the heading "Lessons Learned".[/#0000ff]
[signature]
Reply


Messages In This Thread
Painting spinner blades - by TubeDude - 05-30-2006, 06:43 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-23-2006, 10:36 PM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-23-2006, 11:19 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-23-2006, 11:26 PM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-23-2006, 11:37 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-24-2006, 12:21 AM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-24-2006, 12:34 AM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-24-2006, 01:13 AM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-24-2006, 12:53 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-24-2006, 05:07 PM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-24-2006, 07:51 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-24-2006, 08:09 PM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-24-2006, 08:15 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-24-2006, 08:29 PM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-24-2006, 08:44 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-30-2006, 05:58 PM
Re: [bdn06] Painting spinner blades - by TubeDude - 12-30-2006, 06:09 PM
Re: [TubeDude] Painting spinner blades - by bdn06 - 12-30-2006, 06:20 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)