Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3d printed planer board (can you help me improve it)
#13
(07-06-2022, 01:19 PM)wiperhunter2 Wrote: The orgional one did not have any weight, I'd be careful adding weghts because it could just sink it, if you stop for any reason or slow down.

If you have a hollow cavity in the back like the picture of the one with the pennies only larger and put a piece of Styrofoam in the top half and weight in the bottom it will keep it upright and afloat when stopped and plane in a true vertical position.
Reply


Messages In This Thread
RE: 3d printed planer board (can you help me improve it) - by duofish - 07-06-2022, 02:20 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)